鸟类观察摄像头2号

Bird Cam 2

2024-03-28 01:04:37

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

A much simpler, sturdier design that the first version, and better looking. Only three pieces (four if you print the perch, plus a straight piece of wire.

The camera mount slides in the back of the feeder. I didn't bother sealing around it although you could.

This bird feeder that uses an off-the-shelf Wyze OG wifi camera to get close-up pictures of the birds. The Wyze OG is currently $20, which is a good deal. It has night vision, a light that you Other cam feeders I've seen on here also use Raspberry Pi and build the camera, but for $20 I couldn't be bothered, and this has the app and everything ready to go. You can view live or have it be motion-activated, and it will record any motion-activated events as a picture for later viewing, or will record video if you use an SD card. The app is easy to use.

The camera focuses to far away to be useful, however. So it needs some corrective optics. You need a lens that is 20x magnification and about 20-25mm in diameter. I used a rotary tool with a cutting wheel to get the lens out of this $10 loupe https://a.co/d/8JmiFF1 from Amazon. This will give a focal range of about 1 to 4 inches in front of the camera.

I find the cap stays on without help, but there are holes to push a piece stiff wire through to hold it in place. Bend the end of the wire 90º so you can remove it easily. I used a piece of wire coat hanger initially but it turned out not to be needed.