悬挂式光剑架

Hanging Lightsaber Stand

2024-01-13 05:26:08

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Printing

I printed this on a Bambu, utilizing the AMS to use multiple filaments in the same print. You can accomplish most of this other ways by swapping filament part of the way through the print.

I printed the grate in Silk Silver PLA with Protopasta Steel Filled PLA on the top 4 layers.

The clip was printed in Hatchbox Black PLA. The body was printed in the same, but also using Overture clear PETG for the support interface to make easy to remove supports.

Other parts

Diffusion film
Right angle USB-C cable, 10 ft
Threaded inserts (M2 for grate, M3 for clip)
Socket cap screws (M2 for grate, M3 for clip)
Heat set insert tips
Soldering Iron Make sure it's one compatible with the tips you get
Solder
ESP 8266 board, USB-C
Seed LEDs Amazon, AliExpress (I used the ones from AliExpress)
Wet or dry sandpaper, 150, 220, 400, 800, 1500, 3000 grit
Double sided mounting tape

Assembly

The seed pixels (the LEDs) have three wires. One is marked, that is voltage. that gets soldered to the 5v hole on the ESP. Next one is is signal. I solder that to D4. Final wire is ground, that gets soldered to G.

The wire can just be cut, I recommend going no longer than 30 leds on an ESP board. (you need around 11-12 for this build).

Next you install WLED on the board. You need to have installed the driver. Then go to https://install.wled.me/, plug it in and follow the instructions.

I sanded the grate with each of the listed sandpaper grits to get a good real looking metallic shine, and used thin strips of the mounting tape to stick the LEDs inside, as well as to hold on the ESP on the back. You want to position it such that the right angle USB cable can seat reasonably. Use a soldering iron to sink in the threads, and attach the clip to the front side of the grate. Cut the diffusion paper to size and sandwich that between the base and the grate, Attach the grate with the screws.