紧凑型HW-384 USB外壳

Stubby HW-384 USB Case

2024-01-09 13:30:51

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I have remixed the XT60 USB Charger design to be shorter and to accommodate a cable coming out of the case.
I usually use the HW-384 USB board with Wagos to connect it to my power source, although this remix allows any 6-24VDC connector/cable to be used.
I have also added holes on both sides of the case at the back to allow a small cable tie to be used as strain relief for the connecting cable.
Also tightened up the tolerances of where the board sits inside the case so now the HW-384 board does not move when a USB cable is plugged in and unplugged.
You will need 4 x M3x10mm to screw the two pieces together, at least this is what I used, I don't know what the original designer intended.