六面体谜题带滑动盒子模型

Tetrahex Puzzle with Sliderbox

2023-08-25 17:33:34

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

The puzzle is constructed from 10 puzzle pieces: 3 trihexes and 7 tetrahexes. Each trihex consists of 3 connected hexagons, and each tetrahex consists of 4 connected hexagons.

The puzzle pieces are used on both sides. A lot of different shapes exist for the Tetrahex puzzle.

The lid of the slider box includes a little detent at the end to snap it shut.

3D Printing Tips
The size of the sliding top is crucial. If it's too narrow, the bumps on the top won't snap into place. If it's too wide, the top can usually still be inserted, but it becomes difficult to open. If the lid is slightly too large, you can start by sanding down the bumps slightly. If the top doesn't fit, it is advisable to adjust its dimensions in the slicer and reprint it. Recommended adjustments are only small increments ranging between approximately 0.2mm and 0.3mm in width (only in width).

Here is a short video explaining this:

https://youtu.be/vve-SCg9ln8

I printed the puzzle with the following settings:

Material: PLA
Resolution: 0.2mm
Infill: 20%
no supports
no raft, no brim

If you like check out my other designs too!
https://www.thingiverse.com/pentoma/designs

More information about puzzles whose pieces consist of simple geometric shapes (polyforms) can be found at

http://www.pentoma.de (in german)