可动MWO战斗机 - 改编版

Articulated MWO Marauder - Remix

2023-08-18 17:32:46

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a Re-Mixed Marauder, Leaning on parts of the base from Wolfking. It's poseable, articulates, and needs no glue to hold together. I've changed over the connection scheme to using pins, and a ball socket design, along with a few other tweaks to get the parts to be a bit more printable. Lastly, It's been scaled so that it sits about 7" tall, or about 1:70 Scale

Print List:

1 Foot, 1 Foot Mirrored
1 Lower Leg, 1 Lower Leg Mirrored
1 Upper Leg, 1 Upper Leg Mirrored
2 Knee Pins
1 Waist
1 Torso (Recommend rotating so the nose points up at about 45, or 60 degrees)
1 Upper Arm, 1 Upper Arm Mirrored
1 Lower Arm, 1 Lower Arm Mirrored
2 Arm Pins
7 Split Joints
Optional - 1 Split Joint Installation Tool. This makes putting in the little split joints much easier, but a 7mm wrench can be substituted if desired.

Printing Instructions -
The joints probably should be PETG as they are designed to flex a little when installed, but the rest of the thing should work fine with PLA. The joints may work in PLA too, but i haven't tested them using it. Use supports, and be careful about orientation when placing the parts on the bed. Also, Note: When printing the split joints, and pins, place the flat face on the side on the bed, as this helps with strength. I also recommend printing at a 0.16mm layer height, to help with a few of the overhangs on the back of the mech, but that can be seasoned to taste.

Assembly Instructions:
To install the split joints, first put each into a hole with the little lugs inside. Then twist about 90 degrees to lock it in place. The expectation is that it fits in fairly tightly, but If the fit is too tight, or too loose, re-print the split joint, changing the scale by 1 or 2 percent. A second tip on fit up is to use a small peice of paper wedged between the joint and main body when assembly, in order to tighten up the locking lugs.
Also, note that there are two types of split joint - the long throw variety allows for a slightly larger amount of movement, but pushes the parts farther apart. I usually use them on the ankles and the regular ones elsewhere, but they are interchangeable, so use whichever ones you like.

Other notes:
I've tested the joints between about 70% and 120%, so scaling the mech a bit up or down shouldn't be a problem.
Print Settings
Printer brand:

Creality
Printer:

Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.16
Infill:
20
Filament brand:

Overture
Filament material:

PETG