Garden hose holder to mount against a post

2023-06-25 23:30:14

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Garden hose holder to mount against a post

Summary

Garden hose holder to mount against a post, when you don't want to put holes in the post because it would rust or it's only temporary. It uses 6mm bolts and 10mm hex nuts.

Fits on an ender3 and should be plenty strong. It uses about 230g of filament (bracket included ) and it printed in 5,5 hours. I use a highflow nozzle though.
I exported 4 versions, for posts of 60, 70 and 80mm width. One to mount against a Wall.(here, the centers of the countersunk 6mm mounting holes are 87mm apart.) I only printed the 80mm variant, it works great so far. I used wingnuts to fix it, so if/when the PLA starts to creep, it will be easy to fasten it again. The unshortened bolts in the back are a safety hazard and I will shorten them.

I printed it with an 0.6mm nozzle, 0.8mm extrusion width, 0.4mm layer height. Plenty of nozzle temp for better flow and adhesion. doesn't need a brim or supports, 15% infill doesn't hurt. Use a fan to improve the overhangs.

I used PLA, but from what I've read, that's not a good choice for outside stuff. If there should be any noteworthy degradation in about a year or so, I'll update this post with pics of the dregraded state.