适用于15mm×20mm杆的耳机支架

Headphone Rest Mount for ~15mmx20mm Pole

2024-05-05 22:08:17

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Designed this for my desk pole, figured I might as well upload it in case anyone has the same desk. The holder itself is intended to be printed vertically rather than laying down so that the layer lines look nice, but if your printer is worse than mine it might not work ig. The size of the pole isabout15mm by 20mm, my caliper actually measures 14.5 or smth but it's close enough, if it doesn't fit you can scale it a bit.

It's a bit of a tight fit so be careful getting it on because it's prone to breaking outwards, but once you get it on it should be good. Use the nuts to tighten the clamp around the pole.