Expo 白板记号笔支架

Expo Marker Holder for Whiteboard or Wall

2024-04-30 12:44:53

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

A simple Expo Marker holder that can hold up to 4 markers.

I tried to reduce filament usage by not creating a full enclosure for the markers. Also included 6 circular cutouts on the back to allow to glue magnets to the print. The hole dimensions are 11mm in diameter and 3mm in depth. The holes worked well for 10mm diameter magnets. I tested the print with 6 magnets and found that they do not hold the print in place on the whiteboard. The print would slide down the board until it hits the frame at the bottom. So, this would only work by placing the print at the lower part of your whiteboard if it has frame.

You can orientate the holder in the vertical or horizontal direction. Per Expo, it is recommended to store the markers in the horizontal position.

The width of the of the print where the magnet cutouts are placed have a 17mm width. I believe it's wide enough to accommodate command strips if you prefer to mount the holder onto the wall. I plan to upload another STL file without the holes in order to give a good surface to attach command strips.