Moen龙头芯片提取工具

Moen faucet cartridge pulling tool

2024-04-24 03:47:58

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a simple tool that helped me pull a stuck Moen faucet cartridge. I think it should work for just about any Moen single cartridge faucet but I specifically used it to replace a 1225 cartridge. Print it in the strongest material you have and consider adding additional perimeters and upper/lower surfaces so it does not break.

To use it you will need some washers or nuts that are larger than the thread of the screw that holds the cartridge in. Place the washers on top of the 3d printed part and stick the screw through the hole. The 3d printed part will butt up against the tube that the cartridge is in and as you tighten down the screw it should pull the cartridge out.