Heltec 无线棒 Lite V3 和电池壳

Heltec Wireless Stick Lite V3 and battery case

2024-04-05 01:15:51

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a work in progress. I haven't printed this yet. If you do print this, please give me feedback, and I'll make corrections.

This is a simple case for the Heltec Wireless Stick V3 with a battery compartment. The board slides it from the rear and is held in place by guide rails and a TPU bumper.(shown in black)
It will require (6) M3x10 screws. Be careful when threading them in and go slow to cut the threads. Use of a tap is optional, but a good idea.
Two buttons are required, and must be installed prior to sliding in the board.
The hole on top is 6mm and should fit an SMA style antenna. I intend to wire the cable through the rubber bumper.
Fully assembled dimensions are:
44mm wide
60mm tall (excluding antenna)
78mm long
I chopped up and borrowed the blue and red parts from item 6201288. The USB-C cap is from 6543093.