子弹喂料装置 44型号MAG/SPL

Bullet Feeder Die 44 MAG/SPL

2024-03-27 16:02:24

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Full disclosure, just made this 5 minutes ago and haven't had a chance to try it out yet. Congrats on being a guinea pig! Any and all feedback is appreciated!

Sort and sweet for now, will try to polish the details out later. Should work similarly to my other designs.

Tube size .625 O.D. with I.D. that matches your bullet diameter (44 Magnum/Special = .429in). Bitspower 16mm O.D. tube should work and be cheap online.

Print both parts, clean small holes with 3/32 drill and center hole with 15/64 drill. Glue base insert "green part" in with the large angled edge facing out. MAKE SURE PINS SLIDE SMOOTHLY AND FREELY BEFORE GLUING!!! Pin size 3/32 diameter .75in long.

Recommend teflon tape instead of nut, but whatever works. All parts should thread finger tight.

Print big end down!