Enders 3v2影子模型

Ender 3v2 Shroud

2024-01-17 01:23:27

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Upgraded printer to Spider V3 and discovered stock shroud didn't fit as stated. Made this to replace it. Hanger friction fits over the back plate. Magnets go in holes in hanger and back of shroud. Shroud indexed at top to locate on top of hanger. Magnets on back of shroud hold in place (make sure you match polarities of magnets!)

Fits Ender 3v2 with BLTouch and Spider v3 (should fit any of the Creality hotends)

The magnets I used aren't listed at Amzn any more, but there are many alternatives. I used neodymium magnets I already had on hand. Need 10mm and 6mm.

I'm only using magnets in the top 2 right 10mm and bottom 6mm positions.

Print Settings

Printer brand:
Creality
Printer:
Ender-3 v2
Rafts:
No
Supports:
Doesn't Matter
Infill:
30%
Notes:
Tried with and without support. Version in use was printed without support on Qidi i-Fast. Your results may vary.

Post-Printing

Top and bottom are split for support avoidance. Pegs on bottom of top piece align with holes in top of bottom. Pegs are a tight fit, so some sanding or trimming useful depending on print material. Then glue together. Fan straps screw in with 3mm short screws.