升级版福特车辆电池固定支架，Optima红色顶部

Upgraded Ford Battery Hold Down, Optima Red Top

2024-01-12 13:41:54

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I upgraded my truck battery to an Optima Red Top, but the OEM Ford battery wedge was much too small to secure the battery to the tray.

I designed this upgraded battery wedge to be compatible with the Optima batteries. It's wider (towards the battery), and a little bit shorter (in height) to make sure you can get a good grip on the base of an Optima battery. I can now grab onto the battery and shake the entire truck without the battery sliding around in the tray.

I recommend printing this with TPU, moderate infill, and make the bottom 15-20 layers extra thick solid as this is what the bolt/washer will clamp down on (the bottom layer will become the top of the wedge once installed). The thicker you make the bottom layer the less the TPU will deform while under pressure when tightening this down on the battery.

I'm using this on my 2002 Ford Ranger, but I think this is a pretty common battery mounting design for a lot of Ford vehicles. It may work for your car or truck as well.
The Dorman part number that this design was based off of is 00588, check to see if your vehicle lists the same battery hold down part number, before printing.

Print Settings

Printer brand:
Creality
Printer:
Ender-3 S1
Rafts:
No
Supports:
No
Infill:
Moderate
Filament brand:
Any
Filament material:
TPU
Notes:
Please make your bottom layers solid 15-20 layers thick (bottom layer becomes to top of the battery wedge once installed). This will ensure that the TPU doesn't deform while being clamped down by the through-bolt.