Cute Turtle

2023-09-09 08:08:16

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

50% Larger version using only M3 fasteners can be found here: Cute Turtle V2

Artwork for the design was used from here
I modified this design with the following changes:

Split into parts to be printed in differing colours.
Added ball joints for the flippers to be articulated
Separated the eye to make them movable
Split the bodies up and added fasteners for assembly

You will need the following printed parts:

1 x Head Left (also the main body)
1 x Head right (also the main body)
1 x Flipper Front Left
1 x Flipper Front Right
1 x Flipper Rear Left
1 x Flipper Rear Right
4 x Flipper Ball
4 x Ball Spacer
2 x Eyeball Sclera
2 x Eyeball Iris
2 x Eyeball Pupil
1 x Eye-Spacer
1 x Shell Upper
1 x Shell Lower Left
1 x Shell Lower right

The ball spacer and Eye spacer parts are not visible when assembled so choose any colour for these.

You will need a M2.5 Thread tap and 2.5 Fasteners for the assembly. The Flippers are delicate to tap so be careful. All tap hole are slightly too small so that they can be drilled near first. Fasteners needed

Eyeballs: 2 x M2.5x10mm
Flippers: 4 x M2.5x6mm Cap Head. These must be cap head to fit into ball joints
Shell : 4 x M2.5x10mm (M3 also okay for shell if preferred)
Body: 5 x M2.5x12MM and 5 x M2.5 Nyloc nut

The assembly of the components should be obvious from the diagrams. The shell does not attach to the body it's simply fastener around it instead.

For the Eyeballs I assembled them and then sanded down so they roll inside the head nicely. If you want to avoid sanding print he eye parts at 99% scale.