CSL刹车踏板

CSL Brake Pedal

2023-08-25 17:33:51

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

(Made for Fanatec CSL Pedals w/ Load Cell Brake Kit)

You could use this for any of the pedals, but I made it specifically to use for my brake pedal. I don't like how the original plastic pedal was curve so much. I can control the braking pressure much better with this in place. It also puts the brake pedal slightly higher than the accelerator, which I like.

I was afraid a stand-alone pedal printed out of PLA wouldn't hold up under repeated use, so I designed this to slide over the top of the original pedal. Turns out it works pretty well. Just remove the original brake pedal with the two screws in the back, then slide it into this from the side and screw it back down.

I printed this on it's side, along the front of the printer bed, with supports just for the slot. My printer was able to handle the rounded corners with no trouble

Basic printer settings:
layer height = 0.2 mm
perimeters = 3
top_solid_layers = 3
bottom_solid_layers = 3
infill = 10%
infill type = gyroid